Subfloor repairs · Bouncy floors · Licensed builder

Bearer and Joist Repairs in Sydney

Bearer and joist repairs for Sydney homes with bouncy, sagging or soft floors. We replace rotten, termite damaged or undersized subfloor timber, so your floor feels solid underfoot again.

What Are Bearers and Joists?

If your house has a timber floor, it’s sitting on a frame underneath. Bearers are the big beams that sit on top of the piers or stumps. Joists are the smaller timbers that run across the bearers and your floorboards are nailed onto them. Together they carry the weight of everything in the house: walls, furniture, people, the lot.

When that timber rots, gets eaten by termites, or was never big enough in the first place, the floor above starts to bounce, sag or feel soft in spots. It usually starts small. A bit of spring in the hallway, a dip near the bathroom, a cabinet that rattles when someone walks past. Left alone, it gets worse, because damaged timber keeps weakening and the load shifts onto the timber around it.

In a lot of older Sydney homes, the problem areas are under bathrooms, laundries and kitchens, where leaking pipes and poor airflow keep the subfloor damp for years. Termites are the other big one. They eat timber from the inside out, so the damage often isn’t obvious until the floor starts to give.

Not every job means ripping everything out. Sometimes only a few joists need replacing. Sometimes sound but undersized timber can be strengthened by doubling it up or adding extra support underneath. If the bearers have dropped because the piers or stumps under them have failed, those need fixing too, or the new timber will just sag again.

We check the whole subfloor, work out what’s actually causing the problem and replace or strengthen only what needs it. The result is a floor that feels solid underfoot again.

Before you hire anyone for subfloor work, you can check their builder licence on Service NSW. Ours is on every quote.

New treated pine bearer on adjustable steel piers during bearer and joist repairs
Rotten bearer under a house showing signs it needs bearer and joist repairs

Signs Your Bearers or Joists Need Repair

Why Bearers and Joists Fail

Moisture and rot

Poor ventilation, leaking pipes and water getting under the house keep the timber damp, and eventually it rots. Areas under bathrooms and laundries are often the worst.

Termites

Termites eat subfloor timber from the inside out, so the damage often isn't obvious until the floor starts to give.

Undersized or over-spanned timber

In some older homes, the bearers or joists were never big enough for the distance they span, so the floor has always had some bounce, and it gets worse with age.

Old cuts and DIY work

Joists notched or cut through for old plumbing or wiring lose a lot of their strength, and floors sag above them.

How Our Bearer and Joist Repairs Work

1. Subfloor inspection

We check every bearer and joist, plus the piers or stumps they sit on and find what’s causing the damage. You get a fixed written quote before anything starts.

2. Support the floor

We prop the floor frame so it’s safely supported while the damaged timber comes out.

3. Replace or strengthen

Rotten or damaged sections are cut out and replaced with new treated timber. Where the timber is sound but undersized, we strengthen it by doubling up joists or adding extra support underneath.

4. Check the supports

If the piers or stumps holding the bearers have failed too, we replace them with steel at the same time, so the whole floor is solid.

5. Level and finish

We make sure the floor is level and solid, and clean up underneath. Most bearer and joist repairs take [1 to 3] days.

How Much Do Bearer and Joist Repairs Cost in Sydney?

The cost depends on how much timber needs replacing and what caused the damage. We inspect first and give you a fixed written quote at no cost. The main factors are:

Your quote is the price you pay. If we find more damage once we’re working, we show you and talk it through before going any further.

Recent jobs

Recent Bearer and Joist Job

New LVL bearer on adjustable steel piers during bearer and joist repairs in Greystanes

Bearer installation in Greystanes

The floor in this Greystanes home had gone bouncy, the skirting boards were pulling away from the floor, and cracks were showing in the gyprock. Under the house, the old brick piers had dropped and the floor frame had lost its support. We installed a new LVL bearer to carry the floor, set it on 90x90 steel Ezipier piers, and packed the existing brick piers that were still sound. The floor is solid and level again, and the whole job took 2 days.

Bearer and Joist Repairs Across Sydney

We repair subfloors on homes right across Sydney, from Western Sydney, Parramatta and the Hills to South West Sydney, the Inner West, the North Shore, the Northern Beaches, the Eastern Suburbs and the Sutherland Shire.

Reviews

What customers say

★★★★★ [X.X] from [XX] Google reviews

[Paste a real Google review here. Keep it to three or four lines.]

[First name], [Suburb]

[Paste a real Google review here. Keep it to three or four lines.]

[First name], [Suburb]

[Paste a real Google review here. Keep it to three or four lines.]

[First name], [Suburb]

Tip: swap this grid for a Google reviews widget (e.g. Trustindex) so reviews stay real and update automatically.

FAQs

Bearer and Joist FAQs

Bearers are the large beams that sit directly on the piers or stumps. Joists are the smaller timbers that run across the bearers and hold up the floorboards. If either fails, the floor above will bounce or sag.

Usually it’s rotten, damaged or undersized joists, or bearers that have sagged between the piers. Sometimes the piers or stumps underneath have sunk too. We check both and fix whichever is causing it.

In most cases, no. We work from under the house, so the floorboards and your flooring stay where they are. Floorboards only come up if the damage is right under them and can’t be reached from below.

Yes. We work from under the house, so you can keep living there while we repair the subfloor.

If we find active termites, they need to be treated by a pest controller before we replace the timber, otherwise they’ll move straight into the new wood. We’ll let you know and can work around their treatment.

Most jobs take [1 to 3] days. Bigger jobs, or jobs where the piers or stumps also need replacing, take longer. We give you the timeframe with your quote.

Bouncy Floor? Let's Check Underneath.